Installation of traffic calming devices in bicycle lanes

Summary#

Introduction 1066-2026, sponsored by Council Member Julie Won, would amend New York City’s Administrative Code to require the Department of Transportation (DOT) to install traffic calming devices in bicycle lanes. Its stated goal is to enhance safety for pedestrians and cyclists; the bill does not guarantee a particular safety result. It was laid over in committee on September 30, 2026, and is not law.

  • Within one year after the local law takes effect, DOT must install devices at no fewer than 50 intersections with bicycle lanes where no such device is already installed. DOT chooses the device type.
  • In choosing locations, DOT must consider vehicle and micromobility (such as bicycle and scooter) traffic patterns and congestion; estimated foot traffic; crash and injury counts for vehicle–micromobility, micromobility–pedestrian, multiple-micromobility, and single-micromobility crashes; and topographic features.
  • DOT may decline an otherwise required installation if, in the Commissioner’s judgment, it would endanger motorists, pedestrians, or cyclists, or conflict with relevant department guidelines.
  • DOT must preserve access, entry, exit, and passage for at least authorized emergency vehicles.
  • DOT must study the devices’ effects on daily cyclist numbers and specified crash and injury counts, and recommend maintenance and further installations. It must publish and send a report to the Mayor and Council Speaker between two years and two years six months after the law takes effect.

What it means for you#

  • People walking, cycling, or using streets: Some bicycle lanes may get devices such as redesigns, chicanes, or raised crosswalks. The bill does not name the locations, guarantee a device at any particular intersection, or require every eligible intersection to receive one.
  • Emergency services: DOT must install devices in a way that allows authorized emergency vehicles to pass.
  • Other road users: The bill does not directly impose new duties, fines, or fees on people using the streets.
  • DOT: The department must select locations and devices, conduct the study, and publish the report. The bill does not set a required method for the study.

Money#

No cost estimate or funding source is provided in the available material.

  • DOT must install at least 50 devices and carry out the study and reporting duties, but the bill gives no staffing or spending estimate.

What is unclear#

  • The bill does not set standards for which device to use or how DOT should weigh the required location factors.
  • It does not explain how the Commissioner would decide that an installation would endanger people or conflict with department guidelines.
  • It does not specify the study’s methods or how crash, injury, and cyclist counts should be measured.
  • The bill does not identify the intersections or explain how installation, maintenance, and study costs would be paid.

Case for#

  • A possible argument for the bill is that it requires installations at a minimum number of intersections while directing DOT to consider traffic, crash, injury, pedestrian, and terrain factors.
  • Requiring a later study and public report could provide information on how the installations relate to cyclist numbers, crashes, and injuries.
  • The emergency-vehicle access rule and the safety exception give DOT ways to account for access and safety concerns.

Case against#

  • One concern is that the Commissioner’s power to decline installations could make the 50-intersection minimum less certain in practice.
  • The bill requires DOT to consider many factors but does not say how to balance them or explain how it will choose among locations.
  • The devices are intended to slow, reduce, or alter bicycle-lane traffic; the bill does not specify how their effects on cyclists’ travel will be weighed against the stated safety goal.
  • The bill creates installation and reporting duties without providing a cost estimate or funding source.